Superior NMC004-TD Manuel d'utilisateur télécharger pdf (Page 5)

5

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Periodically (After the Burning Season)

Maintenance Task Accomplishing Person Procedure

Cleaning Firebox Interior

Check Flame Patterns and Flame Height

Checking Vent System

Cleaning Front Glass Enclosure Panel

Homeowner

Homeowner

Homeowner

Homeowner

Carefully remove logs, Rockwool and volcanic

stone if used. Vacuum out interior of the

firebox. Clean firebox walls and log grate.

Replace logs, Rockwool and volcanic stone as

detailed in this manual.

Refer to

Figure 7 on page 7

and verify the

flame pattern and height displayed by the

appliance conforms to the picture. Flames

must not impinge on the logs.

Inspect the vent system at the top and at the

base (within the firebox) for signs of blockage

or obstruction. Look for any signs of disloca-

tion of the vent components.

Clean as necessary following the directions

provided in this manual. DO NOT TOUCH OR

ATTEMPT TO CLEAN GLASS WHILE HOT.

Maintenance Schedule

Annually (Before the onset of the Burning Season)

Maintenance Task Accomplishing Person Procedure

Inspecting/Cleaning Burner, Logs

and Controls

Check Flame Patterns and Flame Height

Inspecting/Cleaning Pilot and Burner

Checking Vent System

Appliance Checkout

Replacing Rockwool Ember Materials

Qualified Service Technician

Qualified Service Technician

Qualified Service Technician

Qualified Service Technician

Qualified Service Technician

Homeowner/Qualified Services Technician

Inspect valve and ensure it is properly operat-

ing. Check piping for leaks. Vacuum the

control compartment, fireplace logs and burner

area.

Refer to

Figure 7

on page 7 and verify the

flame pattern and height displayed by the

appliance conforms to the picture. Flames

must not impinge on the logs.

Refer to

Figure 8 on page 7 (Millivolt) or

Figure 9 on page 7 (Electronic)

. Remove any

surface build-up on pilot and burner assem-

bly. Wipe the pilot nozzles, ignitor/flame rod

and hood. Ensure the pilot flame engulfs the

flame sensor as shown.

Inspect the vent system at the top and at the

base (within the firebox) for signs of blockage

or obstruction. Look for any signs of disloca-

tion of the vent components.

Perform the appropriate appliance checkout

procedure detailed in this manual.

Remove old ember materials and vacuum the

screened rockwool placement area. Place new

rockwool as described in this document.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Commentaires sur ces manuels

Pas de commentaire