Superior NMC004-TD Manuel d'utilisateur télécharger pdf (Page 3)

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Figure 1

Millivolt Appliances -

To light millivolt appliances refer to the detailed

lighting instructions found in both English and

French on

pages 12 and 13

of these instruc-

tions respectively. Millivolt appliance lighting

instructions may also be found on the pull out

lighting instruction labels attached to the gas

control valve. Refer to

Figure 2

to locate the

appropriate location for the piezo ignitor used

with your appliance.

Millivolt appliances may be fitted with an op-

tional ON/OFF Rocker Switch for appliance ON/

OFF control. The optional ON/OFF Rocker switch

will be installed at either the right or the left side

of the Piezo Ignitor on the Piezo Bracket, just

beneath the valve. Once the pilot is lighted, the

ON/OFF rocker switch will control the appliance

ON/OFF operation. To operate: Toggle the

switch between its ON and OFF positions.

If your millivolt appliance is equipped with an

optional remote wall switch or remote control

kit and the pilot is lit, the appliance main burner

may be turned on and off with the wall switch or

remote control.

Electronic Appliances -

To light electronic appliances refer to the de-

tailed lighting instructions found in both En-

glish and French on

pages 14 and 15

of these

instructions respectively. Electronic appliance

lighting instructions may also be found on

the pull out lighting instruction labels at-

tached to the gas control valve. If your elec-

tronic appliance is equipped with an optional

remote wall switch or remote control kit the

appliance main burner may be turned on and

off with the wall switch or remote control.

OPERATION AND CARE OF YOUR

APPLIANCE

Appliance operation may be controlled through

a remotely located optional wall switch. Sepa-

rate switches may provide independent con-

trol for the remote controlled fireplace opera-

tion (optional equipment). In lieu of remote or

remote wall switch operation, the appliance

must be operated directly through the controls

located on the front of the valve located within

the control compartment located behind the

hinged drop down panel below the appliance

front glass enclosure panel,

Figure 1

Gas Controls/Control Compartment Access

The gas controls can be found within the con-

trol compartment behind the hinged drop-down

control compartment access panel comprising

the lower front face of the appliance below the

front glass enclosure panel.

To open the control compartment access panel,

actuate the spring loaded magnetic catches se-

curing the door by gently depressing the outer

top corners of the door until the catches "pop" the

door free, allowing it to swing out and down to

open. Once the control compartment door is

opened, complete access to the gas control

valve and its related controls is attainable.

To ease door closure, depress the catches to

place them in their retracted position until they

stay there, then close the door.

Operation of millivolt and electronic gas control

systems are different. Before lighting and op-

erating your appliance determine if you have a

millivolt or electronic appliance.

Refer to Fig-

ure 1

to access the control compartment. Mil-

livolt appliances will be fitted with the gas

control valve shown in

Figure 2

WARNING: CHILDREN AND ADULTS

SHOULD BE ALERTED TO THE HAZARDS

OF HIGH SURFACE TEMPERATURES. USE

CAUTION AROUND THE APPLIANCE TO

AVOID BURNS OR CLOTHING IGNITION.

YOUNG CHILDREN SHOULD BE CARE-

FULLY SUPERVISED WHEN THEY ARE IN

THE SAME ROOM AS THE APPLIANCE.

WARNING: DO NOT PLACE CLOTHING

OR OTHER FLAMMABLE MATERIALS

ON OR NEAR THIS APPLIANCE.

AVERTISSEMENT: SURVEILLER LES

ENFANTS. GARDER LES VÊTEMENTS,

LES MEUBLES, L'ESSENCE OU AUTRES

LIQUIDES À VAPEUR INFLAMMABLES

LOIN DE L'APPAREIL.

WARNING: FAILURE TO COMPLY WITH

THE INSTALLATION AND OPERATING IN-

STRUCTIONS PROVIDED IN THIS DOCU-

MENT WILL RESULT IN AN IMPROP-

ERLY INSTALLED AND OPERATING AP-

PLIANCE, VOIDING ITS WARRANTY. ANY

CHANGE TO THIS APPLIANCE AND/OR

ITS OPERATING CONTROLS IS DANGER-

OUS. IMPROPER INSTALLATION OR USE

OF THIS APPLIANCE CAN CAUSE SERI-

OUS INJURY OR DEATH FROM FIRE,

BURNS, EXPLOSION OR CARBON MON-

OXIDE POISONING.

Carbon Monoxide Poisoning: Early signs of

carbon monoxide poisoning are similar to the

flu with headaches, dizziness and/or nausea. If

you have these signs, obtain fresh air immedi-

ately. Turn off the gas supply to the appliance

and have it serviced by a qualified profes-

sional, as it may not be operating correctly.

Appliances with electronic systems will be fit-

ted with the electronic valve shown in

Figure 3

Familiarize yourself with the differing controls

for the valve your appliance uses.

Ne pas se servir de cet appareil s'il a été plongé

dans l'eau, complètement ou en partie. Appeler

un technicien qualifié pour inspecter l'appareil et

remplacer toute partie du système de contrôle et

toute commande qui ont été plongés dans l'leau.

Test gage connections are provided on the

front of the millivolt gas control valve (identi-

fied OUT for the manifold side and IN for inlet

pressure. A ¹⁄₈" NPT test gage connection is

provided on the electronic gas control valve

adjacent to the outlet to the main burner.

Minimum inlet gas pressure to these appliances

is 5.0 inches water column (1.24 kPa) for natural

gas and 11 inches water column (2.74 kPa) for

propane for the purpose of input adjustment.

Maximum inlet gas supply pressure to these

appliances is 10.5 inches water column (2.61

kPa) for natural gas and 13.0 inches water

column (3.23 kPa) for propane.

The appliance must be isolated from the gas

supply piping system (by closing its individual

manual shut-off valve) during any pressure test-

ing of the gas supply piping system at test

pressures equal to or less than ¹⁄₂ psig (3.5 kPa).

The appliance and its individual shut-off valve

must be disconnected from the gas supply piping

system during any pressure testing of that system

at pressures in excess of ¹⁄₂ psig (3.5 kPa).

These appliances must not be connected to a

chimney or flue serving a separate solid fuel

burning appliance.

Any safety guard or screen removed for servic-

ing the appliance must be replaced prior to

operating the appliance.

Piezo Ignitor

Drop Down

Control

Compartment

Access Panel

SIT Gas Valve

Honeywell

Gas Valve

Sit and Honeywell Millivolt Gas Valve Showing

Piezo Ignitor Location (Each Unit is Equipped with

Only One of these Gas Valves)

1 2 3 4 5 6 7 8 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Superior NMC004-TD Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Grilles Superior NMC004-TD